i have iveco daily 02 hard to start.a sniff of easy start and it goes ok i bought the van with this problem and tested the low pressure pump changed the fuel filter fitted clear fuel pipes to eliminate air.overhauled the H.P Pump and checked fuel pressure changed every sensor and regulator on the fuel system checked fuel rail pressure reconditioned the injector and tested them and carried out commpression test and all these check out ok to the specification and data recieved from bosch and iveco it still wont start with out easystart can any one help.i understand and experienced that a direct injection engine does not require heat to start does anyone doubt this theory.

bozlynch, October 2008

I have an Iveco Daily, 2002 model. When I turn on the ignition, all lights on dashboard light as usual, but when I try to start it, it turns over but will not start, also the light on the dash which I believe is the immobiliser light, flash`s on and off.I had it looked at and there is no power at the ECU. Any ideas?????

Dan, March 2010

you cannot overhaul an electrical injector without specialist equipment .
there will probably be a faulty injector or check the crank shaft end float it is a common fault on 6.5 tonnes daily but you dont say what engine or model it is

lecky, December 2008

never hold down the throttle pedal when starting. this sends a false reading to the e.c.u. always turn ignition on, wait for 5 secs, then turn ignition to start position, remembering never to touch the throttle pedal until engine is running.try to allow engine a few minutes to warm up from cold in morning starts. this simple step will save many faults from occuring or being stored in e.c.u memory.

bones, November 2008