Had an C2 today and suspected ice, as we had ice in inlet hose yesterday, but a thorough rinse of filter fixed the problem without reset!
ØyvindSP, February 2012
whots error has name: E34????
Piotrek Poland, May 2008
The water won't drain from my Hotpoint Washer - how do I check to see if the drain pump is blocked?
cheryl, December 2006
C 09 brushes are worn out
C E water dispenser faulty. Gears stripped, you will need to replace the complete unit
C D door not shut
C 1 as above
C 2 as above
Some codes require a machine reset. The following works on my machine:
Set selector switch to off
Hold in "pre wash" and "soaking" buttons together
Turn selector switch anti clock from "off" to "short spin"
Turn selector switch clockwise to "energy saving"
Machine should then be ready to use
Dave, April 2006
c1 The water is closed - open up the tap
The inlet hose is blocked - unscrew hose from tap, remove filter and clean under running water
c2 washing has not spun enough, there is water left in drum
a) kink in outlet hose
b) max pumping height is exceeded
c) drain pump is blocked
d) water drainage system is blocked
mrs w, November 2005
A follow up, we get a CE code when on a wash cycle, it doesn't seem to take water in, it will spin, etc,,,
thanks
Andy
