The model is a high spec J32 and just recently does not want to fire up any more. The pilot light is remaining lit . The room stat is set to max. If I turn off the pilot and the mains power switch and allow to cool for ten minutes and then relight the pilot light and reset , it then fires up the burner and works for a couple of mins or so and then just pilot light again. I am trying to get info on what part I may need to change, regards David.

David Forrester, November 2005

two bed house the bath in the middle makes the air and water cold very quickly the j25-32mk3 worked on that system do i need a new type of bath extractor fan

Jitan, April 2010

There is an Air Flow Sensor which makes sure there is enough airflow to operate safely. Check your filter(s) are not blocked and give everything a good clean.

Glen., January 2006

check the fan is working try the summer cooling setting to check the fan...

d.., November 2005