if you have basic diy skills this is dead easy if not replace unit...to repair remove glass unit from frame using silicon go round the edge of the sealed unit outer edge and cover this with silicon,no need to be pretty about this. when it has dried you have then resealed your frame, now to get the water out, drill a small hole in the seal that you have just made right into the airgap between the two panes of glass. now heat the centre of your glass pane with a hair drier for about an hour this will heat up the gap between the panes and drive out the water that is trapped between the panes, when this is done reseal the drilled hole with silicon while the glass is still hot when the glass cools down you will have a vacuum between the glass panes. refit your glass unit and all is well, i have done this loads of times with success. good luck.
willie, December 2005
