Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    John asked ... How to fix my fireplace?    |    Ian Scott asked ... Remove cover off gas boiler?    |    Click here to ask your question

error faut 13 dyson cr01 any ideas?

can anyone help
brian eley, December 2008
F13 - not heating.
Power off, drag machine out onto the floor, remove back cover or tip machine up at an angle. Check the heater, heater connections, thermostat connections and the connections on the timer, (looking for a burnt out terminal or wire). Heater is located at bottom of drum. If testing with a multimeter, disconnect the wiring and take a resistance reading across the terminals - should be around 20 ohms. If heater is blown (broken internal heater wire) it will give an infinite resistance. There should be no continuity between the either terminal and the metal sheath of the heater - if there is, there's an internal short circuit. When removing heater, disconnect wiring, undo central mounting nut and prise it out of its rubber seal - may require some effort. Replace heater, use sealant when refitting rubber seal and ensure it is fully pushed into the recess in the backplate. Make sure the element locates into mounting bracket inside the drum.(look inside the element with a torch and you will see mounting bracket). This bracket ensures that the moving inner drum doesnt strike the element and damage it.

Repair and service your own washing machine. Go to www.2ndwave.co.uk/manual.html

dannyboy, December 2008
link Click here to see other fixes for Dyson CR01.