home Fix label Video label_important DVD Players category Thomson

How can I reset freeview box?

My thomson freeview box has frozen and now will not switch on / off. The red light just stays on I have unpluged and left off for a while but just will not go pass red light. Does any body know if there is a rest

Mike Wordsworth, May 2009

home Fix label Video label_important DVD Players category Thomsondone

got lib on my hitachi freeveiw box cannot get off so cannot get recordings of how to remove libterry2589

terry1590, September 2014

cant remember pass word to sat receiver need to reset for prime so is there a way to reset pass word ?? thanks barry

barry, December 2013

my bush btu250dtr reads 'fail'. I have unpluged it a million times, but yet still read fail. I can't even get a signal fron my antenna to my tv, i got a new one to scan again, but still no signal to my tv.it all started when i wanted to delete a recorded program from my library. What can i do to?

mimi, November 2013

menu, help, green, yellow:)

ellie jones, March 2011

Thanks bud, had two that weren't recordong, did this and both worked first time, I'd send you a tenner for a couple ogf drinks if i had your address. many thanks again.

Tommy, February 2011

Badingo Thank You so much your guide worked perfectly, I think the timings crucial on the button presses though took me four attempts but it reset my box and got my hard drive working again. Thank You !!

Gordon, May 2010

i have a thompson dti 1200 and loads of channels (itv ch4 ch5 itv2 etc) are coming up under ch000 and im not recieving them. iv tried code 2500 in tech info but this made no difference! how can i reset the box that i recieve these channels? thanks

john griffin, February 2010

My thomson free view box just went into stand by and wouldnt get back on doesnt have a re-set batton it just shut down and before that it asked me not to power it off and would re-start but it's now been 4 days it's still on stand by(Red).

Douglas, October 2009

do what bandingo said its actually works. thanks bandingo x

jennie, June 2009

Take power lead out for 20secs hold stand by button in, power up again when red flashes release standby then press in this order up down left right you should see an orange and green light flash for about 60 secs the standby light should go solid red, switch on with remote you will loose any recordings and may need to retune PS it took me 3 attempts but it works

Bandingo, May 2009

link Click here to see other fixes for Thomson.