I have a Fisher & Paykel GW711 Excellence.
the problem is The water start's filling the bowl but the bowl won't turn while filling as it normally dose, then once full and the water stops filling, the adjutator dose nothing. The lights are still on, it's if its just paused. I turnd it off/on nothing changed, then it started beeping with this error code 00111000
When I turned it off at the wall, the adjutator moved slightly l
. Thanks.

francise, September 2009

I ended up replacing the Motor controller board ($170 AUS),,
and that's fixed the problem,,,,,

many thanx to ur help,,,

francise, September 2009

Replaced my RPS,,still the same problem,,,
motor controler is next!!

francise, September 2009

Hi,,
thanx for ur reply,I did the checks for the bowl,all ok,,,
I got my tools and dismanteled few things till i got to the RPS looks ok and clean,roter looks ok no cracks,,
checked the drain pipe and the sensor pipe all ok,,,
2 days ago the washing machine started overfilling!!!!
I think things getting worse,,
I;m thinking of buying a new Motor controller (main board),,
what do u think

By the way ,If I disconnect the power cable from the wall and left it overnight ,the washing machine will work normaly for 2 loads then back to the problem again1

francise, September 2009

A difficult one to advise on. After the bowl has filled the controller does certain checks to determine the bowl status. This code means it was unable to establish a correct state. That could be caused by a number of different reasons, some you can check & some you will need help with. You can check when bowl is empty if the inner spin bowl is free to turn. If it is really tight that could be a problem. Also grip either side of bowl & pull up. The inner bowl should move up easily & drop down with a klunk when you let go. There may be something caught under the bowl if it doesn't. If those checks are ok then you will need to call someone in to test the motor & the RPS attached to the motor with a special tester.

Lincoln Appliance NZ, September 2009