3 hours ago Dot asked ... Russell hobbs?    |    Jon asked ... How do I remove the flywheel. Mountfield 1640h ride on mower?    |    Keith Mumby asked ... Fordson starter solenoid?    |    Suzanne asked ... Washing programme stops after 3 minutes?    |    Rif asked ... Kenwood Dishwasher KID60S20 leaking from front?    |    Click here to ask your question

my aeg 40660 goes through full cycle but does not get hot ?

my aeg 40660 dishwasher goes through full cycle ok but water does not get hot could it be the heater or something else ? if it is heater how do i replace it please ?
lizle, October 2009
The heater on this model is an in line inductive heater and can be replaced by opening the back and is the unit in line with the hose feeding the back center of the washer. Just remove clamps at both ends and unplug electric connectors. Remove unit and replace with new unit.

Joe, April 2010
could be the heater or the main control pcb/relay .heater is in the base at the back.should get around 29 ohms across terminals.remove the control pcb from the fascia panel and check the relay solder joints and pcb tracking around that area

ck, October 2009
link Click here to see other fixes for AEG.