andrew smith asked ... 2009 fiesta 1388 cc titainum?    |    Eric asked ... Strimmer fuel line?    |    Frank asked ... Working fine. No cold air?    |    c.m.brown asked ... Replace chuck on aeg power drill sb2e 700r?    |    tom dimmock asked ... How can i mend the lid on russell hobbs elec?    |    Click here to ask your question

HOW CAN I GET MY MAKITA 14.4 VOLT NICAD DRILL BATTERY TO CHARGE?

HOW CAN I GET MY MAKITA 14.4 VOLT NICAD DRILL DRIVER BATTERIES TO ACCEPT CHARGING AS THEY ARE BOTH DEAD AT THE MOMENT.AND THE DRILL/DRIVER IS USELESS
THANK YOU
BIG JOHN, November 2009
When battiers will not except a charge & pops braker reset, let your charger warm up to the touch & try a few more times.If all falls,pickup rechargable batteries at Radio Shack & use acid core solder{ not resin }doesn,t usually hold or take! Usually you will find 2 -3 bad cells.My 12v batteries cost around $54.oo..new replacement ..I cracked my first 3 old ones with a putty knift; but found easier to just take hacksaw to bottom edge & they just fall out.When done replacing in new batteries tape up bottom...PS don't plug up vent hole at bottom of battery!

modemdad, December 2009
figure out poliarity + - and hook up to a car batt for a few seconds then try charger if it dosent work hook to battery untill it accepts a charge from a charger..

steveredman, December 2009
link Click here to see other fixes for Makita 14.4 Volt NiCad Drill.