andrew smith asked ... 2009 fiesta 1388 cc titainum?    |    Eric asked ... Strimmer fuel line?    |    Frank asked ... Working fine. No cold air?    |    c.m.brown asked ... Replace chuck on aeg power drill sb2e 700r?    |    tom dimmock asked ... How can i mend the lid on russell hobbs elec?    |    Click here to ask your question

how do i fix my hotpoint aquarius df23 dishwasher?

my hotpoint aquarius df23 dishwasher wont fill with water - it runs through all the programs but dry - the water supply is switched on and flows ok as far as the connection with the dishwasher pipe - the filter is clean but the dishwasher has been stood idle for a couple of months
pat, March 2006
hi had the same prob i disconnected the hose from the copper mains pipe and in the end was a tiny water filter that was blocked i just removed it and hay presto clean dishes again

eddie c, July 2010
where can i get the bottom dish holder tray?

tarri crothers, May 2010
check there is no kink in the hose when you put machine in place try it out from units

mick, January 2010
Most likely you have an air lock in the dishwasher.

1. Refill the salt compartment.
2. Turn of the water supply at the mains.
3. Disconnect the diswashers water hose from the mains supply.
4. Lower the water hose and allow any water in it to drain from it.
5. Reconnect it and turn on your mains supply again.

Good luck.

Argus Longjob, October 2008
link Click here to see other fixes for Hotpoint DF23.