I fixed a E20 problem but it recurred so I turned the machine on it's side and cleared the filter properly. I now am getting a E90 code. I have taken the lid off and sprayed WD40 but it is still showing E90. Have 4 loads to get done, what can I try next?

Julie, December 2009

as you look from the front did you lay it on its right side with the soap draw at the highest point?.if so water can escape from the soap draw and find its way in to the control panel/main pcb

ck, December 2009

To get the filter out completely I turned it on it's side, some more water came out. I cleaned filter, replaced it and now on/off light comes on and nothing else! Have taken off lid, sprayed WD40, used hair dryer on it, pressed in all connectors I can see, and nothing!! Thanks ck for your help, you are a gem!!

Julie, December 2009

Did ANY water go on to the display pcb??.If so costly repair may be needed.E90 is a communication error from the display pcb to the main pcb.there is a blue wiring loom with 5 blue wires that goes from the display pcb to the main pcb.if there is a bad connection on this loom then it could be the problem.disconnect and reconnect this loom at both ends and retry.

ck, December 2009