I have an old Bell & Howell 8mm Filmo Master projector that has'nt been used in years. Everything seems to work find but the bottom reel seems to go faster then the feed and take up pulleys and the film gets to tight between the bottom reel and the take up pulley. There is a speed adjustment but it slows down or speeds up the pulley and the bottom reel at the same rate. If anyone can? PLEASE HELP ME.........THANK YOU, SCOTT

scott demurias, December 2009

Scott this is for you or anyone else experiencing this problem. I dove into this a sI could not find anyone to help me. I have a 1934 B&H Filmo 8 which was doing the same thing. Turns out the take up reel gear inside the arm is actually clutched to allow slippage. The gear is sandwiched between to washers and between the washers and the gear were two thin cork discs which were all stuck together and not able to provide the slippage needed. I took the gear out and carefully heated it to melt the old grease and then separated the pieces and cleaned it all off and reinstalled the assembly and after letting it run awhile without a film in it started to do what it was designed to do slip! I have since watched quite a few films with flawless performance. Hope this helps someone else to enjoy these vintage projectors.

best regards, Brian, October 2016

Hello Scott I have a 1934 Filmo 8 that does the exact same thing. Were you ever able to find and fix the problem?

best regards, Brian, September 2016