Machine was in wash cycle.Went into alarm. Continuous beeping every second. Third and fourth wash progress lights from the left are on. {green}.
Spin light on.{red}.
When start/pause button is activated lid lock light comes on and wash progress lights and spin light goes out and beeping stops.
When power button is activated wash progress lights,spin light and beeping come back on.
Have tried switching off machine for period of time but did not fix problem. can you please help. Replaced leaking hot water solenoid valve.

Peter Jones, January 2010

if a washer is off balance will it not spin?

rachel, February 2010

my washer does wash cycle then when goes to spin it wont the machine beeps constantly some of the lights are on then when i press the pause button the lid lock light comes one and it wont do any thing if i leave the washer for a while turned off at the power point then turn it back on go to spin then it will work we were told that it was out of balance we have used a level to level what else can we do???

rachel, February 2010

Fault code 49 is -- The Motor Controller module has measured a voltage from the valve diagnostic
circuit that indicates the cold valve is faulty. The most likely cause is that the valve wiring harness has not been connected correctly or the valve is open circuit. Check wiring plug is connected properly to the cold valve & the pins inside the valve wiring plug are not bent & are making good contact. Next check cold valve solenoid coil for continuity & a resistance of 64 ohms. If wiring & coil is ok then it may be a motor controller fault.

Lincoln Appliance NZ, January 2010