Over the last week we have been haveing water shortages. today the relatively new zanussi built in dishwasher model number zdt6503 wont engage the program. I thought this might be down to no mains water but this is not the case, I have pored water into the dishwasher to see if it will drain and it does when the program is started but then emits a beep constantly and the program stops. I am ownderign if this might be something similar to a safety system built in water pumps for showers when there is no water available. Any suggestions?

Ian Davenport, January 2010

that worked a treat, thanks a million..... the dishes were starting to stack up.....:)

Ian Davenport, January 2010

It may have an air lock in the supply hose or when the water supply returned it may have tripped the pressure sensor in the fill valve, if it has one.
Unplug the dishwasher.
Turn off the water supply to the dishwasher.
Remove the fill hose from the rear of the machine and put the end into the sink or a bucket and then turn the water back on for a few seconds.
Reconnect the hose, turn on the tap and try the dishwasher.

Jeffers, January 2010

yeah tried that, as well as unplugging from mains, but no luck

Ian Davenport, January 2010

press and hold the cancel button for 3 seconds

ck, January 2010