I have an indesit w113 that must have been the worst one off the production line. I recently changed the bearings in the drum and everything went fine. The machine as been running ok since. Now the machine won't start any program at all. The light flashes to say that a program as been selected and it stays lit but all I hear is a click but nothing else happens. When the dial is set to end program it does end program and the light goes back into wait for progam mode ie flashing again so I am assuming the dial is ok any ideas where to check next please...

Dean, April 2006

I have same problem, Select Wash, water goes in and then it stops dead - Checked Drainage, bearings for obviuos signs but no joy.

Its like it knows what wash but the msg to start spinning the drum is not getting there?????

If anyone has a clue please, please post.

Thanks

Frosty1s, May 2007

our one clicks like that,changeing the bearings the bearings are not in right or the belt is not on right plus check for blockages in pipe undersink and filter bottom of machine

caz8694@msn.com, April 2006