Hi,
I've got a Kenwood A701A where the motor starts too fast and reaches full power when it's turned up just past halfway. I've tried Kenwood, but the schematic is no longer available for download. If someone could email me the diagram, that would be great. Or, failing that, does anyone know if there is a way of adjusting the motor/switch?
Many thanks.

davep@sidca.fsnet.co.uk, April 2006

Look on this website www.kenwoodservice.com

I think you will find what you are looking for.

Thanks!

DJT
November 2006

David-James, November 2006

Pretty sure that you get into the machine and speed control is adjusted via two screws with springs. Turn the machine upside down, open the spring base, take out four screws, take out two screws holding slider in place, slide plastic cover out of the way. Two screws with springs should be on side opposide control knob.

Simon, May 2006