Stuart G asked ... C3 Front Wiper control problem?    |    Clare S asked ... Repair Electriq dehumidifier?    |    Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    Click here to ask your question

stihl 041 when it gets hot it dies?

I have a stihl 041 av. It runs and cuts great till it gets hot. Then it starts running rough till it dies. Almost impossible to restart, but I need to let it cool then it does it all over again. I found out the intake is on the bottom of the piston, crank side. Then exhaust is on the top. Was also told that the saw housing may have a crack on the intake side and when it gets hot it opens, causing the saw to die. Has anyone heard of this?
Bob, February 2010
if not the coil check compression my need piston and rings

lendog, September 2012
sounds like you need too adjust the carb. maybe its running too lean?

holeintheknee, March 2010
bad coil, most likley.

buck m, February 2010