hi frank, remove n/s lower dash panel,then you can access motor, to remove it you will need to remove circlip from the short tie rod from linkage to bracket, then very carefully prise off link rod from motor crank arm, from under bonnet remove the 4 13mm nuts holding motor bracket, then from inside lift out motor complete with bracket.dont forget to remove wiring plug.if you need to remove linkage,remove wiper arms [13mm nut on each], remove large nuts on top of spindle bushes,then remove linkage assy from n/s. make sure if replacing motor that crank arm is in correct position for wiper parking![MAKE SURE IGN IS OFF DONT GET YOUR FINGERS/HANDS NEAR LINKAGE WHEN SWITCHED ON .THEY ARE VERY POWERFUL]
k, February 2010
