Hi
I have a Bosch Maxx Washer WAE20260AU/11 with an E2 error on it (probably an unbalanced drum). I know it can be reset but I can't remember exactly how. Can you tell me how to reset it?
Thanks Linda

Linda, May 2010

Thank you very much worked a treat although it didn't flash just reset the display and needed to run through the 15 miniute ez program. Which I let it do!!!
Sandy
April 2024

Sandy, April 2024

This worked for me too - thanks Linda !

Andrew, August 2017

Hi All
Worked a charm fir me
Thanks Linda. Saved me the cost of a repairer.
Michael

Michael, April 2017

Thanks Linda...couldn't fixed it without you.

Carmen, February 2017

Worked like a charm thank you so much :)

Michelle, June 2015

hi my bosch front loader had a code e2 so i done a master reset now the water goes in but the tub does not spin a round when i first switched it on it did for a second thanks bob

robert, March 2015

Linda's reset method worked perfectly for me.

Rod, February 2015

Thank you. Worked perfectly.

Melinda, October 2014

Reset method described in this thread worked like a charm. Thanks.

Scott, January 2011

Thanks a million it worked straight away!!

Brooke, October 2010

I found this by ssnja57....
The e2 error is a generic error that the machine shows if it's been overloaded or if the load becomes unbalanced during a wash cycle.

To fix you must do a master reset of the washing machine.

1. Close the door and make sure the dial is pointing to the "OFF" function
2. Hold the Start/Pause button and turn the dial anti clockwise (to the left) to the "express 15 min" program at the same time.
3. Hold the Start/Pause button for a minute (the e2 message is meant to start flashing after a minute of holding the button down however with my washing machine this didn't happen) (and neither with mine)
4. Release the button and turn the dial back to the "Off" function.
5. Select any program and the message should not be appearing.
This worked for me ... Linda

Linda via ssnja57, May 2010