The trigger gun part number 9.036-694.0 has split with frost over the winter. I am struggling to get a replacement part or trigger. Can someone help. Really can't afford a new pressure washer.
Gorky,
What type of epoxy did you use?
I tried a five minute, two ton epoxy, and let it cure for 24 hours and it failed.
Mike from Cle, August 2015
I successfully fixed two of these with epoxy. It's important to grind down over the crack slightly to create a channel where the epoxy can go into and bond properly. After I fixed these I have used them about 20 times each with no issues. It doesn't mean it that they won't break again but at least I was able to buy me some more time.
Gorky, May 2015
Why not glue over the crack?
Occam, May 2013
Hi Melanie,
Exact same problem. Frost split the SAME part and can't afford a new machine. Hope WE both find an affordable solution!!
Lou, July 2010
Hi Melanie
Unfortunately you have to replace the whole 'gun' part which costs about £30. Check ebay.
I'm in the process of doin the same
good luck
