fisher & paykel top loader washing machine & dryer in one

lilysunshine, June 2010

hi terry,

thanks for your answer.. to be more precise, our washing machine is a F&P GW512 and there are grey hoses linking it to our laundry sink so not a red or blue in sight. However, we can obviously work out which is coming from the cold & hot source. These two hoses lead into the top of the back of our machine and there doesnt seem to be a box that I can access. I think that the machines electrical bits are all inside the control box/panel on the top of the machine... therefore, do you think there is anything I can do myself? thanks again

lilysunshine, June 2010

firsly,take the plug out of the wall socket.On cold and hot water fill machines the cold fill hose is the blue one,yours may be a single one,cold only.The hose is screwed on to a small plastic box called a solenoid which has a couple of wires leading to it.If your machine has two hoses,red and blue,the solenoid on the red hose will be the same as the blue one so try swaping them over,the chances of both of them being faulty is remote.If you just have the single cold fill hose machine try getting a solenod off a scrap machine,you can usually get one from your local waste site.To actually check the solenoid you would have to have it connected to an electrical supply to see if the valve was opening and closing--not for the ameteur.If you do swap the solenoidsover or find a replacement one and the machine still does not fill it may be the pressure valve not clicking on and off.This is a round plastic box about 4 inches diameter which has a thin rubber tube leading to it,this senses when the drum has or hasnt water in it---if it isnt working the the machine will not fill or spin because it is getting the wrong signal from this valve,here again try getting one from a scrap machine.
Good luck,
Terry

terry thomas, June 2010