Hotpoint WD865A stopped mid wash. 8pin chip U2 blown its to?

Hotpoint WD865A Washer Dryer.Just stopped mid wash. Plug,fuse ,mains filter OK. On Main Board IC U2, an eight pin DIL chip, had blown its top!! Probably a low voltage SMPS chip?? But only mark lef ... more

done

hotpoint ultima WD865a?

machine has no display and will not do anything!!The fuse in the plug is fine and there is power to the socket.The power cord looks ok .Its 6 years old and any help much appreciated.

done

LCD display not working hotpoint wd865a washer drier?

the light on my lcd display has been flickering for a while and now has gone completely! can't see what i am doing to use the thing!! can this be repaired? What are the likely costs??

done

Hotpoint WD865A?

How to remove the housing on my hotpoint WD865A as I need to get at the drum.

done

Has anyone experienced the drying problems on this model?

We purchased a Hotpoint WD865A washer dryer,we have had it 3 months,the washing machine has been very good,but the dryer does not dry the clothes, we have just experienced f-13 high temperature rise i ... more

done

I am getting a F-08 message on my Hotpoint WD865A?

I am getting a F-08 message coming up on the screen of my Hotpoint WD865A. Admittedly I did put a little extra liquid in than I normally do but there was a lot of foam inside the drum and it wouldn't ... more

Hotpoint WD865A not heating up / spinning properly!!?

HELP!!! We have a hotpoint wd865A washer dryer which when a wash program is selected, just keeps rocking drum back and forth (As if trying to balance Load)! it does this if no washing in machine!! ... more

done

Thermostat Broke on Hotpoint WD865A / WD860?

I had an F-13 error on my WD865A (WD860) and adjusted the fan so it didn't rub any more. However, now the dryer works but it doesn't heat up the air. Hotpoint suggested the thermostat was broken. D ... more

done

Hotpoint WD865A/WD860 Error F-13 and Dryer Noise?

Hi, I've owned the Hotpoint WD865A (similar to WD860) washer dryer for a year and it's worked fine. However, today I selected a 45 min dry-only cycle on low heat and got an error "F-13" on the scre ... more

done