what is the model number if its a wma model you need to buy the back half of the tub and replace this, if it a wm mdel you can buy the bearings seperate. you need to remove the lid then the dispenser draw and the screws around it this will loosen the control panel youll see 3 screws underneath that and 3 on the bottom holding the front plate on unclip the seal and remove front then remove all small clips holding plastic front on the tub. to remove the drum remove nut and wheel on back of tub and pull out you will see the bearings there. easiest way to remove is to use a bearing removal kit.
daz, June 2006
