hi there,clutch was slipping,so bought a new kit,fitted the kit,now engine wont turn over,feels like its locked up,was ok before,kit fitted,any ideas please...thank you mike
hi,have slackened nuts off a couple of turns on gearbox,now turns,i am just wondering if the clutch kit i was sent was for a dual mass fly wheel,mine is fitted with the normal fly wheel..but i checked everything with the old one,and they look the same.it sounds to me as if it is catching on the gearbox and locking when tightened up..there is no washers on gearbox bolts,and they all look the same length....goingto take apart to check....mike
mike, August 2010
if you have turned engine over backwards whilst doing clutch you might have put timing out..
me, August 2010
does it have any sensors that bolt into bell housing around flywheel area,if so are bolts correct length and washers fitted where they should be.[if too long they may be fouling flywheel.]
k, August 2010
hi again,no all the sockets are accounted for.
mike, August 2010
have you left a socket on one of clutch cover bolts? it's been done before!
