Circular saw can I use this saw to cut into a chipboard floor by tllting up and slowly lowering it to cut into the floor? I have to remove my bathroom floor to replace after a tank burst.
Bungalow no elecs in or through joist they all come down burried in the walls.

Bob, September 2010

Thanks Kash will do as you say.
Main fear was if a clown plumber put a pipe through top part of joists [ was done in my previous house and elecs with no metal guard over it] but checked through hole and all pipes are clear and below the joists, so no chance of a water fountain cutting in to pipes.

Bob, September 2010

yes u can u have to start further back to your cut as the blade doesnt go to depth until 3 inches into the cut set it around 25mm deep as chipboard flooring is 18mm or 22mm deep gl

kash, September 2010