Was anyone able to answer? I have the code.... I just need to know how to enter it!

GH, September 2010

GH for ford.

Late Four Digit Ford Radio Codes ( no SELECT button)
ie. Ford 3000 Traffic, 4000RDS, 5000RDS, 6000RDS, 6006E, etc
Switch the radio on and the word CODE should appear in the display
Repeatedly press button 1 until the correct first digit of the code is displayed.
Repeatedly press button 2 until the correct second digit of the code is displayed.
Repeatedly press button 3 until the correct third digit of the code is displayed.
Repeatedly press button 4 until the correct fourth digit of the code is displayed.
Once the code has been correctly selected on the radio's display, press button 5 to enter.

for renault please look below

hay88, September 2010

GH Renault you must hold at end to store code.
IF YOU DONT HAVE ¬ KEY THEN PUSH THUMBWHEEL IN AND SOME HAVE {A¬} KEY

Turn on the radio and the display will show 'CODE'
Use the steering controls for code entry.
Press the [ ¬] button then rotate the thumb wheel for the correct first digit
Press the [ ¬] button then rotate the thumb wheel for the correct second digit
Press the [ ¬] button then rotate the thumb wheel for the correct third digit
Press the [ ¬] button then rotate the thumb wheel for the correct fourth digit
If the correct code is now shown on screen,
press and hold the [ ¬] button for up to 10 seconds to store the code

FOR NO STEERING CONTROL
press the first preset button for the 1st digit,
second button for the 2nd digit
third button for 3rd digit
forth button for 4th digit
then press buttons 6 OR 5 to store. for 10 seconds

note the radio does not lockout after a wrong code entry it only doubles the time to wait before
the next retry...if a wrong code is entered it will display error then after the delay should display "0000")

Switch on the radio, the display will show 'CODE'(dc449/62)

Press [ 1 ] followed by the station < > buttons to rotate the first digit
Press [ 2 ] followed by the station < > buttons to rotate the second digit
Press [ 3 ] followed by the station < > buttons to rotate the third digit
Press [ 4 ] followed by the station < > buttons to rotate the fourth digit

Finally if the correct code is shown on screen press the [ 1 ] button to save the code

hay88, September 2010