does anybody have an idiots guide on how to bleed, top up, and service the hydraulics on my newly purchased d.b.950 implematic. at the moment it litfs the three point linkage sloooowly and then even slower goes back to its lowest point by its self but if you try to lower it with the control lever ,no matter how slow you try to do it, it comes down quicker than my exs knickers.Can somebody please help (with the tractor not my ex)

bill, tamborine,qld, April 2011

Check you have the right oil in the rear axle. Not water. Not diesel. Not an emulsion. Should be a dipstick to check fill level near the clutch pedal/ gear levers. If this is good, you may have problems with the internal lift ram, or settings of the operating mechanism. Could also check the overload/ bypass valve isn't stuck open. Can I have the ex's number?!!

Sid Chrome, June 2011