Please note that code entry is only possible when a number is flashing in the seperate display. If the display continually shows "CODE" then the unit may be codelocked and will need to be left switched on up for up to two hours to reset before another code entry attempt is possible.
you must hold at the end to store your code.
Code Entry as Follows:
Switch Radio On - Display Shows
" 0000 " with the 1st digit flashing
Rotate " Thumbwheel " For Correct Digit
Press " ¬ " On The Stalk Control To Enter
Rotate " Thumbwheel " For Correct Digit
Press " ¬ " On The Stalk Control To Enter
Rotate " Thumbwheel " For Correct Digit
Press " ¬ " On The Stalk Control To Enter
Rotate " Thumbwheel " For Correct Digit
If the correct code number is now shown
Press And Hold " ¬ " Until A Beep Is Heard
hay88, May 2011
