you will need a torque spit and a ratchet.
you could probably buy a cheap set from super cheap.
usually cheap enough to buy in a set although i think the one you want is a T35.
a bit tricky to fit if you r fitting one on a semi automatic and if you fit it wrong the cylinder will come apart and piss out fluid from the bell housing.
you can re assemble it but not something i would recommend if your not confident
mark, August 2011
not sure but if you remove the horseshoe clip holding the hose into the slave cyl. and remove the hose,then I think you have to turn slave cyl. a/clockwise to remove from bell housing,sorry can`t be more specific.
cdc, July 2011
sorry its a rwd there is a pipe and a bleed nipple and the cylinder is ovel shap going into arourd whitch gos in the bell housing is it a ser clip a bolt thanks
stirling, July 2011
don`t think you need any tools,you haven`t said if its fwd/rwd,if its fwd then its a g/box out job.
