andrew smith asked ... 2009 fiesta 1388 cc titainum?    |    Eric asked ... Strimmer fuel line?    |    Frank asked ... Working fine. No cold air?    |    c.m.brown asked ... Replace chuck on aeg power drill sb2e 700r?    |    tom dimmock asked ... How can i mend the lid on russell hobbs elec?    |    Click here to ask your question

Water does not fill the machine as it should only during the main wash cicl?

Miele Novotronic W820 Washing machine
Water does not fill the machine as it should only during the main wash cycle?
Does the three way water inlet valve need replacing? or is it a pcb board problem?

During the prewash cycle the water fills properly and the cylce works but when trying to do a main wash the water does not fill properly and the cycle never starts?
Daniel, October 2011
General answer.
How do you know it does not fill properly?
I would guess that you have taken it apart. i.e 3 way valve, check valve for blockage, if some water is going in, valve control ok, level sensing, is next, not sure on yours, most level sensing is via a pressure switch, pipe to it can gat blocked up, give wrong reading, look for a 3" dia unit about 1.5-2" thick usually two different colours top and bottom, 2 wires plus pipe. Check pipe. You could allways fit new pipes to the outlets of the valve, going to the sink, check the programs, how much water comes out. If same, valve ok

SD, October 2011
link Click here to see other fixes for Miele W820.