My Dyson CR01 washing machine has the F11 fault and ive replaced the bridge rectifier and the fuse but it still showing the same F11 fault , I also had a spare working powerboard so I tried this on the machine but its still showing the same F11 fault , can anyone help before I have to phone the dyson engineer out.

Thanks
Gary

Gary, November 2011

well since you have replaced the pcb,and assuming the card was ok,.what about checking the motors, and associated wiring.but yes I see your point here, f11 code is a pain to troubleshoot, and one of the hardest faults to trace down.easy for the engineer as he as all the parts at hand,and he will continue to swap the related parts including timer controlls.for the call out fee you could end up with a fully reconditioned dyson here.just seem a bit of a high piice, if it was to be a loose connection.me personally,I would keep the dyson and pay the call out.whatever you decide to do good luck,.

mech monster, November 2011

Yes mate ive tried holding the on button and temp button then releasing and pressing soil type button , it comes up with some diagnostic code , I turned it off and tried it again but same again fault f11

The engineer said it would cost £99 and this would include callout , all parts and labour and a 12 months guarantee for anything else that breaks on the machine , doesn't seem too bad , I was considering buying a different machine but this has been fault free for 4 years and has been a good machine for us

GARY, November 2011

try clearing the code ,could also be a fault with one of the motors or associated wiring eg worn brushes or bad connection usually .do you know how to clear the code?

mech monster, November 2011