With power on, nothing is happening when attempting to start, all is dead. Could it be a fuse in the control panel, it would help if i had the wiring diagram, can i obtain a free diagram - put onscreen? Thanks !!

stuart, November 2011

The MW059 has 2 fuses actually soldered on to the main control board. Very rare for them to blow without a reason so obtaining that type of fuse & soldering it in place is usually time consuming & often a waste of time as it may blow again if there is a fault causing it. Loss of power on the panel can also be a symptom of a faulty drain pump. If the pump is open circuit or the wiring plug has come out then the panel will be dead.

Lincoln Appliance NZ, December 2011

Depending on the module model (board), it will have an ordinary glass fuse - or more likely if it is a Pride model there are 2 fuses soldered into the board, and normally if there has been a power spike or similar, the board itself will be damaged. Blue and green modules have glass fuses, but yellow ones on are integrated. Always run these machines with a surge suppressor. Exchange rebuilt units are available.

Chris, December 2011