1) Drain Motor running? Water draining out? If no, inspect the filter at the front of
the washer combo (lower/ left corner). Remove any / all debris.
2) Water drains good but laundry still wet? Unplug the combo. Remove the rear service
access panel. Locate the plastic DUCT TUBE on the left side and disconnect it at the
bottom location of the tub. Check for heavy lint accumulation--remove all.
3) Remove the top cover of the combo unit. Standing in front of the combo--at the right
rear corner is a BLOWER ASSY. Remove the "phillips" screws from the blower and lift
the blower motor assy out. Check the housing for heavy lint accumulation. Clean as
needed.
Iam assuming you have followed this procedure.If you have recently plumbed the machine in,have you got the hot/cold fill pipes mixed up.The pump should run constantly on the drying cycle,.Water is added in the form of a mist to aid the drying process.The water is metered by the pcb,over metering would suggest a fault with the water inlet valve(tripple water valve) or pcb. Another reason is failure to reach and maintain final spin,this will leave the clothes holding water prior to the dry cycle.Had any error codes? How is the washer connected for drainage, eg connection onto a sink trap allowing water from the sink, to backfill into the washer,due to a blockage.
paul, January 2012
