i have an ignis adl 349/a intergrated dishwasher. it will not heat what ever program it is on it works for about 10- 15 mins then it starts bleeping and the start light flashes 3 times.i was told it was the heater which i have now changed but that has not cured the problem.
This will be a main module fault. We can repair it for £34.90+vat inc return postage. Send it with a note of your name/address/daytime tel no. to EMW Electronics, Millfield, Oxton, notts, NG25 0TD Tel 0115 9652118
EMW, January 2012
Have you ran a test program?.try running a test program.
Set the dishwasher to the 1st program (normally rinse).
Switch off.
Press and hold the start button and whilst holding it, switch on.
Continue holding until the start button light begins flashing.
Release the start button.
Press the start button once.
Close the door.
The machine will now immediately fill with water and run a test cycle.
If it finds a fault, it will stop and the start light will flash a code to you.
Count the flashes BETWEEN PAUSES. 3 flashes indeed suggests a problem with the heater circuit.If the T/stat checks ok,then you have a problem with the heater relay on the pcb.
Press and hold the start button till the light goes out to cancel the test.
paul, January 2012
heater thormostat, it will be wired inline with heater.
