my naiko n2850w tv will not recieve a signal by rf from my digi bo (digihome dv904b) i dont think it is the digi box as i have tried a different make digi box and that did not work.any help cheers

brian, October 2006

if you can tune in normal terestrial channels then the tv is likely fine. check the cabling between the decoder and the tv.
to go further, you need to connect the freeview box via scart so you can see what you're doing, enter its menu and check the RF modulator is enabled. you may also be able to change the UHF output frequency.

romko, October 2006

Most Freeview boxes can't output the Freeview channels via RF they have to be connected via a SCART lead. (That may be why the other box failed.) As to your box if it used to work, try retuning the TV to the box.

Terry, October 2006

it is for freeview and freeview has worked before on the tv in the past but thakyou

brian, October 2006

Is this for freeview if so have you checked that it is available in your area some areas will not be eligible for freeview until 2012.

Verity, October 2006