Hi, I have a Dimplex CXT24 Series G, which last year worked perfectly. This year it worked perfectly when I first turned it on, for 3 days. Then it was stone cold. Then it worked perfectly for one day. This morning it just slightly warm. The immediate heat section works perfectly both times, it is just the storage/overnight part that isn't working. Any ideas what I would need to do/buy to get it working consistently again? Thank you

Hayley, December 2012

Recently moved into house and heater has been switched off. When you switch wall socket (s) on should the red light on the top light up?. Do I need to leave one of the wall switches on all the time. If so is it the one with the fuse in the wall unit?

Steve, December 2018

do you put any wet towels or coats over it to dry?i think yiou will find its the thermal fuse inside the rad that has either tripped,or melted,common faults.to fix turn power off at the fuse box,remove 3 screws at top of the rad ,some have 3 screws at bottom too,remove the knobs and remove the front cover,top right hand of heater at the thermostsat check to see if there is a melted fuse,it looks like a bit of wire ,if this is not there check to see if there is a round disc with a centre pin,press this in,you should here a clck,if you do,then you have fixed the prob the disc is behind the thermostat at right hand side of the rad,some mods have 2 discs,2 one at the left of hand side of the rad,be sure turn power off before you work on it,ok ?you do know you must leave the rad on all the time?the store rad that is,not the convector

mm, December 2012

The trick is to find out where power is lost,the first place I would check is the switch on the wall

toptrish, December 2012