my fisher & paykel Model No MW511 stops working everytime in the 1st phase of wash. i can drain the water and start over again. once its fills water its runs for few seconds and stops again. some time its works all right but since few days nothing is happening.

does anybody had similar problem.

Nis, January 2013

Thanks for help

will call tech then.

Nis, January 2013

If you are sure that when it beeps the 8 lights along the top row show the left hand light off then the next 3 are on and the 4 on the right are off then call a service company. It means the control board is detecting a high power use by the motor. It is usually a fault in the control board and it will have to be replaced. A service person will check the motor & decide which needs replacing. Continuing to start it & try to run it may result in more damage & a higher repair bill.

Lincoln Appliance NZ, January 2013

once the water fills up then it starts its wash process and within seconds stops with continuous beep (beep beep beep beep)

there are three lights on when it stops. they dont flash.

next to power button leave 1st light then 2,3,4 r on.

Nis, January 2013

Need the full details. Does it beep when it stops? What lights along the top row are on when it stops? Are any lights flashing?

Lincoln Appliance NZ, January 2013