The on/off switch at the back lights up when turned to on. However, there is no power to the rest of the machine. Does not heat and will not run. It has an unfinished job in the machine. What might the problem be?

Shelia, September 2013

i should add theres a circuit breaker on the bottom read left side of the machine, they nuisance trip a lot as the breakers age. the breaker is under the machine very close to the main power switch. you can roll the machine on its back to get a good look. try pushing it in to reset. hopefully that will get you going

bob haller service and sales pittsburgh pa 412 366 4906, October 2013

I repair all brands of roll laminators around pittsburgh pa area.

The first thing to check are all the nterlock switches. the clear plastic cover MUST be down, the feed tray must be n place and latched, the interlock switches must all be checked to make certain they are all in their run position, hopefully ts a nice siimple switch problem.

if you care to call me 412 366 4906 I will be glad to call you back, telephone tech support is always free:)

bob haller service and sales pittsburgh pa 412 366 4906, September 2013