Clock has beem cleaned and lubricated. clock will run for hours then stop. can start again but will not run unless a very slight pressure in on the minute hand untill clock gets past stricking at the hour or half hour, then may run for hours or less than one hour.have taken all the wire springs off but left the tension spring on the stricking regulator levers. how do you fix ?

Spunk, October 2013

You state the clock has been cleaned and lubricated. Were new bushings installed? Your clock is lossing power when it goes to lift levers for the strike train. I would first check for warn bushings as one bad bushing will rob your clock of the power it needs.

Stevens Clocks, December 2013