Hi, Wonder if anyone can help. I have a Beko DWD5411W dishwasher. Yesterday there was something of a bang from it and the power tripped. I reset the trip and found that the fuse had also blown in the plug. After replacing the fuse I find that if I power it up it the On/off light solid comes on along with the wash light and the pump starts and attempts to drain the sump. And that all it does, it just keeps pumping. If I press the Start/Stop button for 3 seconds to cancel the cycle the pump keeps running but then the on/off light flashes in opposition to the wash and dry lights which flash together and it just stays like that. Any suggestions anyone ?? All help gratefully received.

Roger, October 2013

my beko dishwasher does not seem to have a leak as no water on floor. it will not enter a wash cycle as water drains out as soon as its filled

trina, April 2020

my water is not heating up

lee, July 2017

Hi, thanks for reply. No water coming out. Whenever I switch on a motor runs as though its trying to pump out. After a while that stops and if I press Start button Wash light comes on as normal but nothing happens, then, after a while pump cuts in again and so it goes. Can't figure the fault lights out on this model, as I mentioned if I press Start button and hold it, then Wash and Dry lights flash together but in opposition to Power light. If I hold Power button in and then power up machine the Dry light comes on and stays on but nothing happens. I'm guessing the pcb is buried in the door ??

RogB, October 2013

lay on its back and see if water comes out.sounds like heater or motor went bang.could of damaged pcb??

CK, October 2013