how do these fix in to the ribber and stay on, its been 20 years since I last used it, even with the manual it doesn't work help!!!

a cross knit, January 2014

Hi Sue
I have used the clamps and inserted the setting plates into the knit bed. My problem is the fittings (L & R with the supports), that connect to ribber to the knit bed. They are NOT attached to the ribber bed. How do I Attach them?

Pat, March 2014

The fittings that attach the ribber to the knit bed have become detached. How do I re attach them? I have two fitting, maked L and R, and can't find the correct location on the rear of the ribber bed. The ribber bed keeps falling on the floor.

Pat, March 2014

Hi,
Have you used the clamps which come with the ribber to set the main machine up at an angle? Once you have done this the ribber slots into the ends of the main bed - I take it that you already have the fittings in place at each end. Then you fold down the supports at the back of the ribber and secure them to the table with the clamps which were supplied with the main machine, i.e. the flat ones. The machine and ribber should now be securely joined together and clamped to the table, both at an angle of about 45 degrees to the table.
Hope this helps.
Regards,

Sue, January 2014