I tried tilting several times, Tried all cycles including reset. Water is entering the dishwasher but light comes on and stays on after about 1 minute into cycle. Has anyone any further ideas I can try please?
thanks

Phil, October 2014

Kenjo,
I'm just tidying up my computer and realise that I didn't thank you for your impellor jug solution. That was the problem and by replacing it, it now works. The hardest part was taking off the plastic cover at the back. In the end, I had to break it and its now back with the help of super glue.
Thanks again for your help.
Have a nice Christmas
Phil

Phil, December 2014

Kenjo
Thanks very much for this. I have ordered the 'jug' and hopefully with my poor DIY skills I will be able to change it.I will let you know how I get on.
thanks again
Phil

Phil, October 2014

Hi Phil, your particular flow meter is situated between the inlet valve and the side water jacket. To access it unplug machine,remove the left hand side panel(2 screws on front edge) you may have to remove the worktop to release the panel.The flow meter is a round white unit with blue pipes on it, remove the pipe that goes to the large water jacket, prise open the square panel holding the inlet water valve at rear and pull out meter through rear. Part is called an "impellor jug" part no 00424099. Cheers

Kenjo, October 2014

Thanks for this,
The model no. is SGS55CO2GB/01 and production no. is 8509 005316
thanks

Phil, October 2014

Your water "flow meter" is probably faulty... it is a device which sends electrical pulses to the module to tell it how much water is going in. When it is faulty the module thinks no water is entering as it has no pulses, so puts up the check water sign. type of unit depends on model no (etched into the top of the stainless steel door) give me this no. if you want diy instructions, cheers

Kenjo, October 2014