Laminator runs fine for about 2-3 feet of lamination, then just stops-power is on, heat is on, rollers just stop. When the machine is turned off for a few minutes and cools some then the rollers will work again. Any suggestions?

thanks so much

drfcajun, December 2014

Bob, thanks so very much I called gbc and they want $600 to go through my door. Just bought machine,it is clean,looks almost new and I was going to try to keep it if I can figure this out machine is in very good shape. am in Louisiana and bought it from a lady in Arkansas. Will cost her if I ship back. laminates great. Tried reverse when it stops-doesn't work. Hear a clicking noise when I press,reverse. wait a few minutes and all works..will call tomorrow..

Drfcajun, December 2014

Hi I fix roll laminators for a livingall thru the pittsburgh area, have been servicing machines my entire adult life since 1975.
When the machine stalls try pushing the reverse switch and see if it runs ok backward. This is the most common symptom of failed heat roll bearings. They lock up in forward but usually run backward OK.

Feel free to call me telephone help is always free:)

bob haller service and sales 412 848 0101, December 2014