Alan asked ... Problem with JCB 3CX transmission?    |    Lou asked ... Mac Allister 35cm electric lawn mower?    |    Ronald Charlwood asked ... Beko fridge/freezer not cold enough?    |    John Broadbent asked ... Advise?    |    suzy asked ... Brother kh-940 not in sync with DAK9 in interactive knitting?    |    Click here to ask your question

What is fault code for F&P GW711?

3rd green, 6th orange and 8th red with beep every second continuisly. This starts at the end of the wash cycle. I have looked at pump underneath at it seem ok. Can you help?
Shane, December 2015
Code 37 blocked pump error. You need to take pump out & check for any obstruction up inside bowl opening. Then check the resistance of the drain pump coil it should be 33.5 ohms approx. slightly more or less is ok. (That is if you have 230Volt power) I don't know what country you are in. If ohms are good & no blockage then it could be a control board fault, not sending any or enough power to the pump.

Lincoln Appliance NZ, December 2015