Replace drive belt on my CO1 wàshing machine

Mike davenport, January 2016

Remove back panel and check the belt is off or on,mine was off which I am pretty certain was the problem,everything is working correctly but there was no obvious adjustment to replace the belt,so I managed to position it with the help of a good strong piece of cord and a large screw driver to expand and position it at the same time,after ten attempts I did it

Mike davenport, January 2016

It's a Dyson machine - you didn't say...

It will be an inside job - you will have to get access to the drive belt area - very probably from the rear.

Good Luck..., January 2016