hi, i have a hot point 1200, it spins and cleans the clothes but when it does its final spin, ie to get rid of the water, it does not spin.

it will sit there making the clicking noise's as the m/c is going through its cycles.!! hope i am explaining this well!!! i have to turn the dial about to make it spin and this only happens after about 5 or so times. i think its an intermitent fault.

craig stuart, December 2006

hi if its not turning at all its brushes if its not turning on the spin either the pump is blocked or circuit board fault

phil grimshaw, December 2006

Craig, hi it's Andy here. Seems like we may have the same problem. I have an Aquarius 1100, and it has stopped spinning. It will not even revolve at the start. I have been told this is a brush problem, but want to make sure, so I have posted a question. If it is the brushes, then I think they are twenty five quid to replace (a lot less than the 35.00 callout and 52.00 for the brushes, which I have been quoted).

AndyC, December 2006