Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    John asked ... How to fix my fireplace?    |    Ian Scott asked ... Remove cover off gas boiler?    |    Click here to ask your question

My IDL40 does not fully empty?

I cannot get the machine to fully empty of water can you please advise me what to do
Bill, December 2016
It's an Indesit dishwasher.

Sometimes on any dishwasher crud collects right down at the bottom where the impeller of the drain pump sits - the pump stalls and the water doesn't fully empty.

Remove the filters at the bottom and bail out the water. Take off the cover over the drain pump impeller - usually a single Torx screw. Use tweezers to lift away the debris - small bones - lemon pips - bits of foil.

Then you're back in business with any luck...

Good Luck..., December 2016