Also check that the seal around the Salt cover is tight some time when refilling with salt it slacens as you unsrew the salt cap allowing water to pour in usealley resulting in tripping your pcb
Rob, May 2009
This worked for me and saved me a call-out bill
Jack, February 2005
Water has got into the very base of the machine & lifted the the flood switch float. Pull the appliance out & tip it back at 45 degrees until any water comes out from underneath for a couple of mins then set it back down & try it. Sometimes its a one off fault but if it happens again check your filters are clean as this restricts the flow and causes it to overfill.
