Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    John asked ... How to fix my fireplace?    |    Ian Scott asked ... Remove cover off gas boiler?    |    Click here to ask your question

carburator settings?

I would like to know the carb settings on a model 2150 poulan chainsaw,the carb is a walbro wt 324,on the high and low settings
mark, January 2007
always start walbro carbys ,screw both screws in till just done up then take out 1.5 turns saw should start then use high speed screw to optimise saw at full revs the low speed screw is for when you give throttle a quick burst so optomise the setting to get no delay in sudden bursts of throttle I think this should solve problem use idle screw to adjust revs at idle

Paul Grimwood, January 2007