Sarah
It may be easier to get an engineer to do it as we are familiar with the process, but heres the outline:
Unplug the printer from the mains.
** Ensure the printer has been swithed off for some time as the fuser reaches very high Temperatures!**
1 Open the toner cartridge door.
2 Grasp the rear of the DIMM cover and pull it away from the printer until it stops.
3 Grasp the front and rear of the cover and swing it out from the printer.
4 Open the rear output bin until it stops and then pull it again so that it rests parallel with the floor.
5 Remove the two screws at the top left & right of the printer rear.
6 Pull the bottom-left corner of the rear cover, then pull the rear cover down and then out to remove it.
7 Now disconnect the left cable to the fuser and use a flat blade scewdriver to remove the right cable connector.
8 Remove the two grounding plate screws at the bottom of the fuser and slowly pull the fuser out.
9 Reverse the above intructions to install the new fuser.
For further help email info@blackgecko.co.uk
Black Gecko, June 2004
